TM 5-3895-373-20
15.8.
REPLACE CONVEYOR DRAG BAR.
This task covers:
a. Remove
b. Install
INITIAL SETUP
Tools:
Personnel Required:
General mechanic’s automotive tool kit
Two 62B construction equipment repairers. Second person
(Item 54, Appendix E)
needed to assist in running machine to position drag bar
and
Crowbar (Item 11, Appendix E)
to assist in drag bar removal.
Drive pin punch set (Item 35, Appendix E)
Torque wrench (Item 68, Appendix E)
References:
TM 5-3895-373-10
Materials/Parts:
TM 5-3895-373-24P
Cleaning cloth (Item 7, Appendix C)
Thread locking compound (Item 12, Appendix C)
Equipment Condition:
Thread locking compound solvent (Item 25, Appendix C)
Hopper wings fully lowered per TM 5-3895-373-10.
Conveyor drag bar
Flow gates fully open per TM 5-3895-373-10.
Spring pins
NOTE
There are a total of 28 conveyor drag
bars on the left hand and right hand
conveyor chain assemblies. This
procedure refers to replacing one drag
bar on the left hand conveyor chain
assembly. This procedure should be used,
as needed, to replace any or all conveyor
drag bars on left hand or right hand
conveyor chain assemblies. Left hand
conveyor chain assembly is shown in this
procedure.
A.
REMOVE.
1.
REMOVE SPRING PINS FROM CONVEYOR
DRAG BAR.
a.
Raise left (1), right (2), and center (3) access
doors on the front of the hopper.
GO TO NEXT PAGE
15-60
