2. REMOVE CONVEYOR DRAG BAR FROM CONVEYOR CHAIN ASSEMBLY

A. REMOVE - Continued - TM-5-3895-373-20_1091

1. INSTALL CONVEYOR DRAG BAR ONTO CONVEYOR CHAIN ASSEMBLY

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
1084

TM 5-3895-373-20 15.8. REPLACE CONVEYOR DRAG BAR - Continued. A. REMOVE - Continued. 2. REMOVE CONVEYOR DRAG BAR FROM CONVEYOR CHAIN ASSEMBLY. a. Start the paving machine. Refer to TM 53895- 373-10. b. Have second person activate conveyor. When drag bar to be replaced is centered in hopper, signal second person to stop conveyor. c. Shut off engine and remove key from ignition switch. Refer to TM 5-3895-373-10. d. Remove hex head cap screw (7) and flat washer (8) from conveyor drag plate guard (9) in the hopper. e. Lift the unsecured end of conveyor drag plate guard (9) and place a support block under it. GO TO NEXT PAGE 15-62

Privacy Statement
Press Release
Contact