3. RECONNECT HYDRAULIC HOSES

B. INSTALL - Continued - TM-5-3895-373-20_1083

15.7. ADJUST CONVEYOR CHAIN ASSEMBLY TENSION

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
1076

TM 5-3895-373-20 15.6. REPLACE HOPPER LIFT CYLINDER Continued. B. INSTALL Continued. 3. RECONNECT HYDRAULIC HOSES. Hydraulic fitting sealant can cause eye damage or skin irritation. Wash after skin contact. Wear safety goggles/glasses when using. Avoid contact with eyes or skin. If sealant contacts eyes, flush eyes with water and get immediate medical attention. a. Apply hydraulic fitting sealant to exposed threads on straight adapters (15 and 16). b. Reconnect hydraulic hose (8) tagged "inlet" to lower port straight adapter (15). Tighten hose. c. Reconnect hydraulic hose (9) tagged "outlet" to upper port straight adapter (16). Tighten hose. The hopper wing weighs 875 lbs (397 kg). Ensure hoist and slings are in good working condition and have adequate lifting capacity to support hopper wing. Failure to use adequate lifting equipment may result in serious injury or death. d. Slowly lower overhead hoist until hopper wing is in the full-open position. Remove C-clamps (1), chain assembly (3), and overhead hoist (4) from hopper wing (2). END OF TASK 15-54

Privacy Statement
Press Release
Contact