TM 5-3895-371-24&P
Remove spray bar as follows:
(4)
(a)
Repeat steps (a) thru (g) for right side of spray bar. (Refer to para 2-38a (1).)
(b)
Disconnect line (12, fig. 2-55) from ball joint (11) and remove gasket (18).
Remove two cotter pins (1, fig. 2-60) and two flat washers (2); then disconnect
connecting rods%) from swivel toggle assembly (3).
(d) Remove two cotter pins from swivel pin (9, fig. 2-56) then drive out pin (9) and
remove thrust washer (7).
Remove carry arm assembly (10).
(e)
LEGEND:
1. COTTER PIN (2)
2. WASHER (2)
3. SWIVEL TOGGLE ASSEMBLY
4. SPRAY BAR
5. CONNECTING ROD (2)
TA 075868
Figure 2-60. Disconnect/Connect Swivel Toggle Rods.
2-117
