TM 5-3895-371-24&P
(1)
Remove left carry arm assembly (10) and left hinge section (1) as follows:
(a) Disconnect chain (2) from left hinge section (1) by removing capscrew (6), sleeve
(3), washer (4), and lockwasher (5).
(6)
Disconnect adjusting link (4, fig. 2-57) by removing cotter pin and clevis pin (7).
(c)
Disconnect two chains (1) by removing a cotter pin and clevis pin (2) from each.
Disconnect spring link (11) by removing cotter pin and clevis pin (12).
(d)
(e) Remove three nuts (13) and lockwashers that fasten the two halves of hinge
section (10) together; then remove the lower half with spacer ring (5) and packing (6).
(f) Disconnect pipe nut (9) that fastens end tube assembly (8) to hinge section ( 10)
and remove the end tube assembly (8).
(g)
Support spray bar with floor jack.
(h)
Remove four capscrews ( 17) and flange gasket (18).
(i)
Disconnect line (30, fig. 2-55) from transfer valve by removing locknut (31). Re-
move gasket (32).
(i)
Remove hand lift lever (14, fig. 2-57) by removing cotter pin (19).
(k)
Remove snap ring (16); then take off arm (15).
(l) Remove two cotter pins from swivel pin (9, fig. 2-56); then drive out pin (9) and
remove thrust washer (7).
(m) Remove left carry arm assembly (10) with attached tubing and place in suitable
vise.
2-112
