TM 5-3895-371-24 & P
Install hose (28) to air control box (7) and air cylinder (13).
(6)
Install hose (27) to bottom of air control box (7) and 'T' fitting (29).
(7)
Install hose (26) to bottom of 'T' fitting on air control box (7) and air cylinder (13).
(8)
Install hose (24) to `T' fitting on air control box (7) and air cylinder (20).
(9)
Install hose (25) to bottom of 'T' fitting on air control box (7) and 'T' (34).
(10)
Install hose (23) to 'T' fitting on air control box (7) and air cylinder (20).
(11)
Install hose (22) to air control box (7) and air cylinder (17).
(12)
Install hose (21) to air control box (7) and air cylinder (17).
(13)
Install new nylon ties (19) securing hoses to tubes above rear crossbrace.
(14)
Install hose (8) to side of air control box (7).
(15)
(16) Set tubing (9) into three tubing retainers (10) on outer LH frame rail; secure with three
each bolts, washers, and nuts.
Install hose (8) to tubing (9).
(17)
Install hoses (4) to tubing (9).
(18)
Install hose (5) to 'T' fitting (12) on back of air reservoir (11) located behind stowage
(19)
box.
(20) Route hoses (4) and (5) along top of front crossbrace and secure to other lines with new
nylon ties (6).
Install hose (4) to air lubricator (1).
(21)
Install hose (5) to gage on air lubricator (1) and reinstall air pressure gage (35).
(22)
Install hose (2) to air lubricator (1) and solenoid air valve (3).
(23)
Start engine, pressurize air system and check for leaks.
(24)
Section XVIII. MAINTENANCE OF SPRAY BAR CONTROL CYLINDERS
2-22. Spray Bar Control Cylinders.
Removal of Bar Sifting Control Cylinder. (Refer to fig. 2-20.)
a.
Disconnect air lines (15) and (1) from elbows (10) and (7). Tag each line to aid in
(1)
reassembly.
2-53
