TM 5-3895-371-24 & P
(2)
Remove cotter pin and disconnect linkage at left side of cylinder.
(3)
At opposite end of cylinder, remove capscrew, washer, and nut; then lift out cylinder.
Installation of Top Bar On-Off Cylinder. (Refer to fig. 2-22.)
f.
(1) Position cylinder on vehicle frame and connect linkage at left side of cylinder. Secure
with cotter pin.
(2)
Adjust length of yoke at opposite end of cylinder to line up holes in yoke with hole in
frame.
(3)
Install capscrew, washer, and nut; then tighten locknut.
(4)
Reconnect air lines to cylinder.
Removal of Bar Turn-Up Cylinders. (Refer to fig. 2-23.)
g.
NOTE
Procedures for removing and installing the left and
right side cylinders are identical.
(1)
Disconnect two air lines from cylinder.
2-58
