TM 5-3895-371-10
Section III - TROUBLESHOOTING
3-6. Introduction.
a.
This section contains information for locating and correcting most of the operating troubles which may develop in
the Bituminous Distributor. Each malfunction for an individual component, unit, or subsystem is followed by a list
of tests or inspections which will help you to determine corrective action to take. You should perform the
tests/inspections and corrective actions in the order listed.
b.
This manual cannot list all malfunctions that may occur, nor all tests or inspections and corrective actions. If a
malfunction is not listed or is not corrected by listed corrective actions, notify your supervisor.
c.
Table 3-2 lists the common malfunctions which you may find during the operation or maintenance of the
Bituminous Distributor or its components. They are listed in the following order
Malfunction No
1
Pump will not turn or turns slowly
2
Burners inoperative or operating improperly
3
Quadrant lever slows or stops pump when moving from circulating in tank to circulating in bar
4.
Spray streaks
5
Spray fogs
6
Spray lacks pressure
7.
Application rate varies
8
Spray bar does not circulate
9
Spray bar does not turn up properly
10
Spray bar inoperable/clogged
11
Circulating system inoperable/clogged
3-9
