TM 5-3895-356-14&P
tube (16). See Fig. 79. Care must be taken not to
damage transfer tube O-ring (14) as the transfer tube
(17) is being positioned in control housing (57). Install
four lock washers (13) and hex nuts (12) on studs (15)
and torque to 72 in. lbs. Care should be taken to torque
the hex nuts (12) gradually and in sequence to insure
proper seating of the cylinder cover (43) and to minimize
the possibility of twisting a stud to the breaking point.
Figure 177.
Cylinder with servo plunger
Figure 178.
Cylinder cover with transfer tube
NOTE:
If servicing a Low Pressure Servo Control, proceed
to Step 18.
110
