• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
FILLING FROM SUPPLY SOURCE
HEATING BITUMEN IN DISTRIBUTORS

Technical Manual For Distributor, Bituminous Material Truck Mounted, 1500 Gallon (Cce) Page Navigation
  5    6    7    8    9  10  11    12    13    14    15  
img
TM 5-3895-356-14&P
loaded at faster pump speeds.
unless you are sure that material is
3. If you pct to heat material
20
3
Maximum 240 G.P.M.
free of all foreign material (Note
further
in
Distributor,
allow
10. If you plan on heating
Below).,
sufficient space for expansion.
material further in Distributor, allow
2. If you do not want material
4. If Distributor i to be filed
20
sufficient space for expansion
to enter pump and circulating
with
hot
bitumen,
proceed
16
system, have intake valve lever in
cautiously if there is any moisture
extreme Up, position.  On units
in tank, or if emulsion was used in
Filling Through Manhole
with inside closing valve operated
the previous load.  Dow-Corning
by handwheel on top of tank at
DC-200 may be used to prevent
1. Always
use
manhole
rear, close valve by turning wheel
foaming.
strainer
clockwise.
Discharge Strainer
Lit cigarettes or other  ounces of
3
combustion must remain clear of
open manholes or overflow vents
to reduce fire hazard.
4
Sparks from engine exhaust can
be a source of Ignition to volatile
Figure 12
gases.
Should pump fail to function
Monthly check and f necessary
properly check, clean and reinstall
7
clean 3" overflow tube to insure
discharge  strainer  (Note  The
tube has not become clogged.
discharge  filter  often  becomes
clogged when the manhole strainer
Fill line cap or connection must be
13
is not used, or when rags and other
securely attached before operating
debns are allowed to enter the tank
intake valve lever to eliminate
through the manhole)
momentary discharge.
Inlet Strainer
16
If moisture is present m tank, do
not load with material having a
temperature over 200 degrees F.
When filling unit m which moisture
may be present m the spray bar or
circulating system, allow a small
portion of hot material to circulate
m bar before fining tank thus
prevent foaming
Figure 13
If moisture is present do not heat
Should  pump  fail  to  suck
material over 200 degrees F A
17
properly check, clean and reinstall
inlet strainer
Cover flues at least 6" before
20
heating
material
to
prevent
explosion
10


Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved.