TM 5-3895-385-23-2
0298
Auger Motor Hoses Inspection
1. Inspect hydraulic hoses (Figure 1, Items 2, 3, 4, 5, 7, 9, 10, 12, and 13) and fittings for cracks, holes, wear, or
deformities. Replace hydraulic hoses if damaged.
2. Inspect hydraulic fittings on motors, bulkheads, tee fittings, and hoses for cracks, stripped threading, wear, or
deformities. Replace component if damaged.
END OF TASK
Auger Motor Hoses Installation
1. Remove caps/plugs from hydraulic hoses and hydraulic fittings.
2. Connect hydraulic hose 27 (Figure 2, Item 2) and hydraulic hose 53 (Figure 2, Item 3) onto bulkhead (Figure
2, Item 1) and auger/conveyor hydraulic pump (Figure 2, Item 4).
3. Connect hydraulic hose 86A (Figure 1, Item 9), hydraulic hose 85 (Figure 1, Item 10), hydraulic hose 90
(Figure 1, Item 12), and hydraulic hose 84 (Figure 1, Item 13) onto left auger motor (Figure 1, Item 11).
4. Connect hydraulic hose 83 (Figure 1, Item 2), hydraulic hose 91 (Figure 1, Item 3), hydraulic hose 82 (Figure
1, Item 4), hydraulic hose 87 (Figure 1, Item 7), hydraulic hose 85 (Figure 1, Item 10), hydraulic hose 90
(Figure 1, Item 12), and hydraulic hose 84 (Figure 1, Item 13) onto bulkhead (Figure 1, Item 1).
5. Connect hydraulic hose 86B (Figure 1, Item 5), hydraulic hose 87 (Figure 1, Item 7), and hydraulic hose 86A
(Figure 1, Item 9) onto tee fitting (Figure 1, Item 8).
6. Connect hydraulic hose 83 (Figure 1, Item 2), hydraulic hose 91 (Figure 1, Item 3), hydraulic hose 82 (Figure
1, Item 4), and hydraulic hose 86B (Figure 1, Item 5) onto right auger motor (Figure 1, Item 6).
END OF TASK
FOLLOW-ON TASK
1. Install engine hood assembly (WP 0433).
2. Install upper rear wear plate (WP 0276).
3. Verify proper operation.
4. Dispose of hydraulic oil and wiping rags In Accordance With (IAW) local Standard Operating Procedure
(SOP).
END OF TASK
END OF WORK PACKAGE
0298-5/6 blank