TM 5-3895-385-23-1
0212
Table 1. Right Control Pedestal Display Malfunction Troubleshooting Procedures -- Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
4. Measure for continuity (WP
1. If continuity is present, proceed
0443, Vol 3) from C15 J1 pin B
to next test.
to C15 J2 pin B (WP 0451, Vol
3, Figure 49).
2. If no continuity is present,
replace damaged
communication cable (WP 0386,
Vol 2).
5. Measure for continuity (WP
1. If continuity is present, proceed
0443, Vol 3) from C15 J1 pin C
to next malfunction.
to C15 J2 pin C (WP 0451, Vol
3, Figure 49).
2. If no continuity is present,
replace damaged
communication cable (WP 0386,
Vol 2).
13.Communication cable C15 has
1. Measure for continuity (WP
1. If continuity is present, replace
short circuit.
0443, Vol 3) from C15 J1 pin A
damaged communication cable
to every other pin on C15 J1
(WP 0386, Vol 2).
(WP 0451, Vol 3, Figure 49).
2. If no continuity is present,
proceed to next test.
2. Measure for continuity (WP
1. If continuity is present, replace
0443, Vol 3) from C15 J1 pin B
damaged communication cable
to every other pin on C15 J1
(WP 0386, Vol 2).
(WP 0451, Vol 3, Figure 49).
2. If no continuity is present,
proceed to next test.
3. Measure for continuity (WP
1. If continuity is present, replace
0443, Vol 3) from C15 J1 pin C
damaged communication cable
to every other pin on C15 J1
(WP 0386, Vol 2).
(WP 0451, Vol 3, Figure 49).
2. If no continuity is present,
proceed to next malfunction.
14. Screed controller (Electronic
1. Disconnect main wiring harness
Control Module (ECM)) has
W1 J1 from screed controller
damage or loose pin.
module ECM (WP 0451, Vol 3,
Figure 1).
0212-6