TM 5-3895-385-23-1
0212
Table 1. Right Control Pedestal Display Malfunction Troubleshooting Procedures -- Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
20. Main wiring harness has an
1. Measure for continuity (WP
1. If continuity is present, proceed
open circuit.
0443, Vol 3) between main
to next test.
wiring harness W1 J2 Pin 3 and
main wiring harness W1 J28 Pin
A (WP 0451, Vol 3, Figure 2).
2. If no continuity is present,
replace main wiring harness
(WP 0373, Vol 2).
2. Measure for continuity (WP
1. If continuity is present, proceed
0443, Vol 3) between main
to next test.
wiring harness W1 J2 Pin 4 and
main wiring harness W1 J28 Pin
B (WP 0451, Vol 3, Figure 2).
2. If no continuity is present,
replace main wiring harness
(WP 0373, Vol 2).
3. Measure for continuity (WP
1. If continuity is present, proceed
0443, Vol 3) between main
to next malfunction.
wiring harness W1 J2 Pin 5 and
main wiring harness W1 J28 Pin
C (WP 0451, Vol 3, Figure 2).
2. If no continuity is present,
replace main wiring harness
(WP 0373, Vol 2).
21. Main wiring harness has a short
1. Measure for continuity (WP
1. If continuity is present, replace
circuit.
0443, Vol 3) between main
main hydraulic manifold wiring
wiring harness W1 J2 Pin 3 and
harness (WP 0373, Vol 2).
all other pins on the main wiring
harness W1 J2 (WP 0451, Vol 3,
Figure 2).
2. If no continuity is present,
proceed to next test.
2. Measure for continuity (WP
1. If continuity is present, replace
0443, Vol 3) between main
main hydraulic manifold wiring
wiring harness W1 J2 Pin 4 and
harness (WP 0373, Vol 2).
all other pins on the main wiring
harness W1 J2 (WP 0451, Vol 3,
Figure 2).
2. If no continuity is present,
proceed to next test.
0212-9