TM 5-3895-385-23-1
0080
Table 1. Engine Failure To Run After Starting -- Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. If no fuel flows into container,
replace fuel supply hose (WP
0331, Vol 2).
4. Fuel pressure drop across fuel
1. Install fuse box (WP 0277, Vol
filter.
2).
2. Connect battery cables (WP
0357, Vol 2).
3. Disconnect fuel filter inlet line
from fuel filter head. Attach fuel
pressure gauge and adapter
(WP 0448, Vol 3, Figure 56).
4. Start engine (TM 5-3895-385-
1. If engine starts and fuel pressure
10) and idle, or if engine fails to
range at fuel filter inlet is
start, measure pressure while
between 73 pounds per square
cranking.
inch (psi) (503 kiloPascals (kPa))
and 189 psi (1303 kPa), record
pressure, turn keyless engine
switch to OFF position (TM 5-
3895-385-10), restore equipment
to original condition, and go to
next test.
2. If engine does not start and fuel
filter inlet pressure at engine
cranking is between 44 psi (303
kPa) and 160 psi (1103 kPa),
record pressure, turn keyless
engine switch to OFF position
(TM 5-3895-385-10), restore
equipment to original condition,
and go to next test.
3. If engine starts and fuel pressure
at fuel filter inlet is not between
73 psi (503 kPa) and 189 psi
(1303 kPa), turn keyless engine
switch to OFF position (TM 5-
3895-385-10), and replace fuel
pump (WP 0329, Vol 2).
0080-3