TM 5-3895-385-23-1
0079
Table 1. Engine Failure To Start -- Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
13.Fuel injection lines damaged or
Inspect fuel injector lines for
1. If damaged or leaking, replace
leaking.
damage or leaks (WP 0337, Vol
fuel injector lines (WP 0337, Vol
2).
2).
2. If not damaged or leaking,
proceed to next malfunction.
14.Fuel injector drain flow
1. Disconnect the fuel drain line
malfunction.
from the fuel pressure relief
valve (WP 0448, Vol 3, Figure
55).
2. Connect pressure gauge
adapter to the fuel drain line
from the fuel pressure relief
valve and run into drain pan.
3. Disconnect the fuel drain line
from cylinder head (WP 0331,
Vol 2).
NOTE
Make sure beaker and fuel leak tester line are below the cylinder head connection point.
4. Install fuel leak tester on fuel
drain line port on cylinder head
and block off fuel drain line.
Run hose from fuel leak tester
into beaker (WP 0448, Vol 3,
Figure 50).
5. Start engine (TM 5-3895-385-
1. If fuel flow is greater than 120 ml
10) and run at idle for 30
per minute (4 fluid ounce (fl-oz)
seconds, or if engine fails to
per minute) maximum at idle or
start, measure fuel flow output
90 ml per minute (3 fl-oz per
while cranking for 30 seconds.
minute) maximum while
cranking, turn keyless engine
switch to OFF position (TM 5-
3895-385-10), and proceed to
next malfunction.
0079-6
