TM 5-3895-385-10
0013
Table 1. Preventive Maintenance Checks and Services (PMCS) Instructions -- Continued.
ITEM TO BE
CHECKED OR
ITEM
EQUIPMENT NOT
NO.
READY/AVAILABLE IF:
SERVICED
INTERVAL
PROCEDURE
62
Before
Right Screed
a. Ensure right slope lowers and
Slope fails to raise and
Control
raises (WP 0004).
lower.
b. Ensure augers raise and
Augers fail to raise and
lower (WP 0004).
lower.
c.
Ensure right tow point
Tow point hydraulic
hydraulic cylinder raises and
cylinders fail to raise and
lowers (WP 0004).
lower.
d. Ensure right cutoff raises and
Cutoff fails to raise and
lowers (WP 0004).
lower.
e. Ensure horn functions
Horn fails to operate.
properly (WP 0004).
63
During
Display Screen
a. Check fuel gauge to ensure
Gauge is below 25%.
Indicators
fuel is at least 25% filled (WP
b. Ensure low battery, high
Low battery, high coolant
coolant temp, high hydraulic
temp, high hydraulic oil
oil temp, and low engine oil
temp, or low engine oil
psi fault lights are not on (WP
psi fault lights are on.
c.
Ensure voltmeter and oil
Gauge is above or below
pressure gauge is not above
normal range.
or below normal range (WP
WARNING
Hydraulic system operates at high temperature and pressure. Contact with high-pressure
liquids can cause burns and scalding. Shut down BMPM and allow system to cool before
performing services and maintenance. Wear gloves, additional protective clothing, and
goggles as required. Failure to comply may cause injury or death to personnel.
64
During
Hydraulic Oil
a. Periodically check hydraulic
Hydraulic oil temperature
oil level and temperature. Fill
exceeds prescribed level.
oil as necessary (WP 0019).
0013-23
