TM 5-3895-385-10
0006
ADJUST PILE HEIGHT USING AUTOMATIC AUGER/CONVEYOR SETTING (REQUIRES SONIC AUGER
SENSORS)
Figure 18. Screed Control -- Automatic Pile Height.
NOTE
Sonic auger sensors must be installed for automatic pile height function to operate.
1. Press and release desired (left or right) auger/conveyor ON/OFF key (Figure 18, Item 1) until LED indicates
ON is selected. Engine speed will automatically raise to 1500 rpm.
2. Press and release desired (left or right) auger/conveyor auto/man key (Figure 18, Item 2) until LED indicates
automatic is selected.
3. Press and hold desired (left or right) material height auger/conveyor speed plus (+) key (Figure 18, Item 3) to
increase pile height to desired level, and then release key.
4. Press and hold desired (left or right) material height auger/conveyor speed minus (-) key (Figure 18, Item 4) to
reduce pile height to desired level, and then release key.
5. Press and release desired (left or right) auger/conveyor ON/OFF key (Figure 18, Item 1) until LED indicates
OFF is selected to turn off augers and conveyors.
END OF TASK