TM 5-3895-373-34
NOTE
There is a left hand and a right hand
track chain assembly on the paving
machine. This procedure refers to
replacement of right hand track chain
assembly. Procedure is identical for
left hand track chain assembly. Right
hand track chain assembly is shown
in this procedure.
A.
REMOVE.
1.
DISCONNECT
TRACK
TENSIONING
CYLINDER HOSE.
NOTE
The master pin has a cone shaped
indent at its center. All other chain
link pins are flat faced.
a.
Start paving machine per TM 5-3895-373-10.
Rotate track until master pin is at upper front
portion of track idler roller.
WARNING
Shut off engine and remove key from
ignition switch prior to performing
track chain assembly maintenance.
Failure to do so may result in sudden
equipment
movement
causing
serious injury or death to personnel.
b.
Shut off engine and remove key from ignition
switch per TM 5-3895-373-10.
c.
Remove track pads on each side of chain
master pin per TM 5-3895-373-20.
GO TO NEXT PAGE
2-559
