TM 5-3895-373-34
D.
INSTALL - Continued.
6.
INSTALL TRACK DRIVE HUB IN PAVING
MACHINE.
a.
Install hex head cap screw (3) with large flat
washer (7) and hex nut (8) from tools list. Install
cap screw in mounting hole opposite from drain
hole in small diameter of track drive hub section.
WARNING
Track
drive
hub
weighs
approximately 125 lbs (57 kg). To
avoid personal injury, use a hoist
when lifting track drive hub. Ensure
lifting chain, hook, etc. are in good
condition and are of correct capacity.
The lifting hook must not be side
loaded.
Personnel shall stay clear of objects
being lifted during hoist operations.
Do not work on objects suspended
by a hoist. A swinging or shifting
load may cause serious injury or
death to personnel.
b.
Hook chain of overhead hoist to installed hex
head cap screw (3). Raise track drive hub (5).
WARNING
Track
drive
hub
weighs
approximately 125 lbs (57 kg). Make
sure full weight of track drive hub is
supported on transmission jack and
that track drive hub is not allowed to
roll. Careless handling of track drive
hub could result in serious injury to
personnel or damage to equipment.
c.
Lower and position large flange of track drive
hub (5) on transmission jack. Install 3-1/2 in.
(88 mm) high cribbing between track drive hub
and jack support plate.
GO TO NEXT PAGE
2-555
