TM 5-3895-373-34
B.
DISASSEMBLE - Continued.
Use care when removing snap and
retaining rings. Snap and retaining
rings are under spring tension and
can act as projectiles when released
and could cause severe eye injury.
k.
Use snap ring pliers to remove retaining
ring (65) from gearbox housing (61).
Discard retaining ring.
I.
Using hydraulic press frame, turn large
flange of gearbox housing (61) down. Use
driver (Item 4, Appendix C) to press out
bearing (66). Discard annular ball bearing.
3.
DISASSEMBLE ANGLE DRIVE UNIT.
a.
Use snap ring plier to remove retaining ring
(67). Discard retaining ring.
b.
Insert hammer handle into splined center of
angle drive unit (64) and push out thrust
plate (68).
Use
caution
when
removing
preformed packings. Scratched or
dented
seal
grooves
can
cause
bypass
leakage.
Do
not
use
excessive
force
when
removing
preformed packings. Use an o-ring
tool to remove preformed packings.
c.
Use an o-ring tool to remove preformed
packing (69). Discard preformed packing.
GO TO NEXT PAGE
2-479
