TM 5-3895-373-34
2.27
REPLACE/REPAIR HIGH SPEED SHIFT VALVE.
A.
REMOVE Continued.
2.
REMOVE HIGH SPEED SHIFT VALVE.
a.
Remove bolts (9), sleeve spacers (10), and
ground wire (11) from mounting bracket (12).
b.
Remove high speed shift valve (3) and mounting
bracket (12) from engine cowling.
B.
DISASSEMBLE.
NOTE
If replacing complete high speed shift
valve,
perform
only
those
disassembly
and
assembly
tasks
necessary to remove and install the
mounting
bracket,
hydraulic
fittings, and electrical cable onto
new valve. The new valve body must
be removed from the subplate to
install the valve socket head cap
screw mounting screws that hold the
valve to the mounting bracket.
1.
REMOVE ELECTRICAL CABLE.
a. Remove screws (13), identification plate (14), and
plate (15)
Gasket
(16)
should
remain in plate.
b.
Loosen terminal screws (17).
c.
Loosen and remove clamp screws (19) from
electrical box connector (18).
d.
Unscrew electrical box connector (18) and pull
connector harness leads from electrical housing
on high speed shift valve (3).
GO TO NEXT PAGE -
2-360
