TM 5-3895-373-20
A.
REMOVE - Continued.
2.
REMOVE
OPERATOR
CONTROL
CONSOLE
GAUGE
PANEL
ACCESS
DOORS.
a.
Open gauge panel access doors per TM
5-3895-373-10.
b.
Remove hex nuts (22), washers (23),
screws (24), and gauge panel access door
(25).
Cleaning solvent, PD680, is TOXIC
and flammable. Wear protective
goggles and gloves. Use only in a
well ventilated area. Avoid contact
with skin, eyes, and clothes, and do
not breathe vapors. Keep away from
heat or flame. Never smoke when
using solvent; the flashpoint for Type
m cleaning solvent is 200°F (93,3°C).
Failure to do so may result in injury
or death to personnel.
If personnel become dizzy when
using cleaning solvent, immediately
get fresh air and medical help. If
solvent contacts skin or clothes,
flush with cold water. If solvent
contacts eyes, flush eyes with water
and get immediate medical attention.
c.
Remove door seal (26) from gauge panel
access door (25). Use a cleaning cloth
soaked in cleaning solvent to remove
adhesive from door and console surfaces.
Scrape off adhesive and gasket residue
with a putty knife if necessary.
GO TO NEXT PAGE
11-5
