TM 5-3895-373-2015.9.REPLACE AUGER FLIGHTS - Continued.A.REMOVE - Continued.f.Rotate augers until hex nuts (1) are horizontal.Shut off engine and remove key from ignitionswitch per TM 53895-373-10.2.REMOVE AUGER FLIGHT.CAUTIONIf auger flights are loose on auger shaft,loose auger flights should be held orotherwise secured while removing hexnuts. Unsecured auger flight(s) may fallto floor and break.a.Remove hex nuts (1), lockwashers (2), and hemiauger flights (3) or quarter auger flight (4).Carefully slide freed flight from auger shaft (5).Discard lockwashers.b.Remove teflon flat washers (6). Discard teflonflat washers.c.Remove hex head cap screws (7), hemi augerflight (8), and teflon flat washers (9) from augershaft (5). Discard teflon flat washers.B.CLEAN.1.CLEAN HEX HEAD CAP SCREWS.WARNINGThread locking compound solvent cancause eye damage. Wear safetygoggles/glasses when using. Avoid contactwith eyes. If solvent contacts eyes, flusheyes with water and get immediatemedical attention.a.Clean threads of hex head cap screws withthread locking compound solvent.b.Use cleaning cloths to wipe residue from hexhead cap screw threads.GO TO NEXT PAGE15-68
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
