TM 5-3895-373-10
e.
Place travel switch in F/R position and speed
range switch in travel (hare) position.
f.
Slowly move both control handles to fully forward
position and ford stream. No special lubrication
or drainage procedures are required after
fording.
2.28 EMERGENCY PROCEDURES.
2.28.1 Offloadinq Residual Asphalt. In an emergency
situation where a fully loaded hopper has to be emptied
immediately, use the following procedures to empty all
paving material from the hopper.
CAUTION
Use care when retracting extension
screeds with any bolt-on extensions
installed. Maximum retraction with
bolt-on extensions is limited to 1 ft
(305 mm) per side. Damage to
endgates will
result
if
extension
screeds are retracted too far.
NOTE
Both paving machine operator and
screed crew are needed to quickly
perform
an
emergency
hopper
offload.
a.
Retract extension screeds if extended, using
extension screed control switches (1).
2-101
