TM 5-3895-371-24 & PSection VIII. REPAIR OF ASPHALT TANK AND HOSES3-9. Asphalt Tank.a. Removal.(1) On the right side, remove fuel tank (para 2-27).(2) Remove eight nuts on top of spring mounting bolts securing tank to the frame (fig. 3-105).(3) Remove three bolts holding fuel lines to tank (fig. 3-106).(4) Remove three fender bolts at center of fender (fig. 3-107).(5) Remove one bolt at rear of right fender brace (fig. 3-109).(6) Remove four bolts from tank bracket to sub frame (fig. 4-11).(7) Lift off intake hoses and hand spray hose (fig. 4-9).(8) Remove eight bolts from walkway brackets and remove walkway (see para 4-3).(9) Remove two smoke stacks (para 2-28).(10) Remove quadrant (para 2-29).(11) Remove air inlet tube (4) from low pressure burners (para 2-39).(12) Remove low pressure burners (para 2-39).(13) Remove asphalt pump (para 3-7).(14) Remove intake valve lever (para 2-30).(15) Remove vacu-flo valve indicator (10, fig. 3-109) by removing four capscrews (11), twonuts (14), and two nuts (15).(16) On the left side, remove four bolts, tank to sub-frame (fig. 4-11).(17) Remove step from rear fender (fig. 5-3).(18) Remove air line (3) from control box (fig. 4.5).(19) Remove brace bolt from fender to tank brace (fig. 5-3).(20) Remove three bolts at center of fender (fig. 3-107).(21) Remove three clamp bolts and nuts holding air hoses to tank (fig. 3-106).(22) Remove two air lines from supply tank (fig. 3-114).(23) Remove two bolts from air supply tank and remove air tank (fig. 3-114).(24) Remove lamp wiring harness (para 2-10, fig. 2-3).(25) Remove bell assembly (para 2-12).3-88
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business