TM 5-3895-371-24 & P(6)Lubricate the entire inner surface of cylinder tube (26) with clean transmission oil.Install tube (261 over piston assembly (27) and seat tube (26) against housing (5). (Refer to fig. 3-53.)Figure 3-53. Cylinder with Servo Plunger.(7)Install two new O-rings (33, fig. 3-54) on each end of transfer tube (34). Lubricate theends of transfer tube (34) and insert in cylinder cover (22). Install cylinder cover (22) with new O-ring(20) and transfer tube over studs (21) and seat into end of tube (26). Care must be taken not to damagetransfer tube O-ring (33) as the transfer tube (34) is being positioned in housing (5). Install four lock-,washers (24) and hex nuts (23) on studs (21) and torque. to 6 Ib-ft (8 N•m). Care should be taken totorque the hex nuts (23) gradually and in sequence to insure proper seating of the cylinder cover (22)and to minimize the possibility of twisting a stud to the breaking point.Figure 3-54. Cylinder Cover with Transfer Tube.3-45
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
