TM 5-3895-371-24 & P(6)Replace O-ring (49) on mounting flange (55), line up bolt holes, and secure assem-bly (51) to mounting flange (55) with four capscrews (52) and lockwashers (2). Torque bolts to 11 lb-ft(14.9 N.m). (Refer to fig. 3-29.)(7)If trunnion bearings (40, fig. 3-4) were removed from cam assembly (42) during dis-assembly, install new trunnion bearings (40) using an arbor press and a 1-1/2 in. plug, pressing againstthe lettered side of the trunnion bearing. It is extremely important that the bearing be started straightinto the born. If the bearing cocks at any time during assembly, remove and discard the bearing Sup-port the cam lug on the under side to avoid bending the lug. Outer face of trunnion bearing (40) shouldbe pressed flush with outer face of cam assembly (42).Figure 3-29. Installing Shaft Seal Retainer.3 - 2 8
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business