TM 5-3895-371-24 & P
(13)
Tap the sides of the bolt hole counterbores lightly to break the gasket seal. Using a
screwdriver, remove seal assembly (51, fig. 3-26).
Figure 3-26. Removing Shaft Assembly.
(14)
Remove shaft seal (50, fig. 3-4) from seal assembly (51) using an arbor press and a 2-1/2
in. plug.
(15) Remove O-ring (49) from flange.
(16)
Remove pump shaft and assembled parts, pump shaft (53), ball bearing (48), retaining
ring (47), retaining ring (12) and inner race of bearing (13) by pulling straight up from mounting flange
(55), as shown in figure 3-27.
(17)
Inspect bail bearing (48, fig. 3-27) for galling, roughness, or cage cracks. If damage is
evident, remove retaining rings (47) using snapring pliers and press ball bearing (48) from shaft.
Figure 3-27. Removing Shaft Seal Retainer.
3-25
