TM 5-3895-371-24 & P
Remove two cotter pins (9) and drive out swivel pin (5) up through yoke (42). Remove
(1)
spacer (6).
Remove cotter pin (12) and pin (11) and disconnect clevis (10).
(2)
i.
Remove cotter pin (25) and pin (26) and pull off clevis (23).
Remove shaft assembly (20) as follows:
j.
Shaft assembly (20) is under great spring tension. Exer-
cise caution when removing.
while removing two capscrews (36, fig. 5-4), nuts (40), and washers (41); then lower pipe wrench to
relieve spring tension.
Figure 5-5. Remove/Install Raising Bar Spring.
5-6
