TM 5-3895371-24&P
Table 3-1. Direct Support and General Support Troubleshooting (Continued).
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
PUMP WILL NOT TURN OR TURNS SLOWLY (Continued):
3.
Low oil level in reservoir.
Step 5.
Replenish oil. (Refer to LO 5-3895-371-12.)
Spray bar control valves set improperly.
Step 6.
Reset controls.
Section I I I. GENERAL MAINTENANCE
3-4. General Repair Practices.
When maintenance is authorized for a special component or part, and no special tools are
a.
given in this manual, you should understand that only standard shop practice techniques are required
to perform the task. Included in this category is the replacement of a drive shaft universal joint as shown
in figure 3-1 and the procedure explained in paragraph 2-14-c where only shop tools and techniques arc
used.
b.
Refer to Appendix A for references to other manuals for general maintenance information.
(Such as, welding, inspection and maintenance of bearings, etc.)
TA075871
Figure 3-1. Replace Drive Shaft Universal.
3-3
