TM 5-3895-371-24 & P
( 2 ) Remove cotter pin and pin from each end of cylinder; then lift out cylinder.
Installation of Bar Turn-Up Cylinders. (Refer to fig. 2-23.)
h.
(1)
Connect fixed position yoke to control linkage and secure with pin and cotter pin.
(2) Adjust length of yoke at opposite end of cylinder to line up holes in yoke with hole in
connecting linkage; then install pin and cotter pin.
(3) Tighten locknut.
(4)
Reconnect two air lines to cylinder.
Repeat steps above for removal and replacement of opposite side cylinder.
(5)
Section XIX. MAINTENANCE OF BITUMETER WHEEL ASSEMBLY
2-23. Bitumeter Wheel Assembly.
Removal of Bitumeter Wheel Solenoid Valve and Air Chamber. (Refer to fig. 2-24.)
a.
(1) Close main air valve; then exhaust air pressure from bituminous supply tank by opening
drain petcock.
2-60
