TM 5-3895371-24 & P
(2)
Remove acorn nut and washer (fig. 26) then lift off bell and washer,
(3)
Remove bell assembly (4, fig. 2-5) by removing two capscrews (3), nuts, and washers.
b.
(1)
Remove acorn nut and washer; then lift off bell (if not previously removed).
(2)
Remove two springs by unhooking from their retaining posts.
Reassembly. (Refer to fig. 26.) Connect both springs to their retaining posts.
c.
d.
(1)
Mount bell (4) on support bracket and secure with two capscrews (3) with washers
and nuts,
gap between the actuating arm striker (5) and the bell (4) (fig. 2-5).
(3)
Connect lanyard to actuating arm (6) and secure with screw (1).
(4)
Pull lanyard at rear of vehicle to check operation of bell.
Figure 2-6. Disassemble/Assemble Bell Mechanism.
2-25
