TM 5-3895-356-14&P
BURNER SYSTEM
GENERAL
BURNER VALVE STRAINER
The burner fuel system includes a fuel tank, pump, fuel
lines with a strainer, shut off valve and pressure relief
a. Removal. Remove the cap and strainer (1, Fig.
valve. The burner fuel tank is mounted on the right side
81) assembly and gasket from the burner fuel valve.
of distributor. The fuel pump is mounted on the burner
air blower and is driven by a blower shaft through a
b. Clean and inspect. Repair or replace damaged
coupling. The burners are mounted on the left rear side
parts.
of the storage tank.
c. Reassemble in reverse order.
BURNER FUEL LINES
a. Remove the Fuel Lines. Remove the tube nuts
(2, Fig. 78) securing the tube assemblies (3) to the
adapters (5) and remove the tube nuts from the tee
fitting of the fuel supply line. Remove the tube assembly.
Remove the adapters from the elbows (4) and remove
the elbows from the left and right fuel burner valves (6)
and (8).
b. Clean ana inspect. Repair or replace damaged
parts.
c. Reassemble in reverse order.
BURNER FUEL LINE STRAINER
a. Removal
(1) Remove the pipe plug and drain the fuel
from the lines.
(2) Remove the reducer bushing and slip the
strainer out. See figure 80.
b. Clean and inspect. Replace or repair damaged
parts.
c. Reassemble in reverse order
Figure 78. Burner Fuel System Diagram
57
