APPENDIX Q
ASPHALT PAVER LUBRICATION CHART
LOCATION
ITEM REQUIRING
LUBRICATING INSTRUCTIONS
TEXACO LUBRICANT
LUBRICATION
RECOMMENDED
Engine:
Refer to Lubrication Requirement In Engine Instruction Manual.
A
Main Transmission:
Keep filled to show I/4" on dipstick. Sight glass must show oil
B
flow during operation. Seasonally, drain, back-flush filter
screen and case. Drain and re-fill with fresh lubricant (See
instruction Manual - Section 11 for details).
Power Transfer Cases:
Keep filled to level hole. Seasonally, drain, flush and re-fill with
C
fresh lubricant.
Bearings and Pivot Points
One pump of gun each day.
D
Bearings and Pivot Points:
one pump of gun each week.
E
Chains. Track Drive Chains
Each day spray all track pins. Spray all slat conveyor chains
F
(complete loops). Remove deck plates and spray both track
drive chains. (Use oil spray accessories from screed heater
system).
Bearings
Seasonally wash out and repack bearings and lube chamber.
G
Replace grease seals (See Instruction Manual - Section 11).
Track Idlers:
Seasonally remove plugs, install temporary fitting, add grease
H
until fresh grease extrudes from opposite hole. Remove plugs.
Conveyor Drive Chains:
Once each week coat all conveyor drive chains lightly.
K
*IMPORTANT NOTE:
Never mix brands of lubricant in paver gear cases. Chemical inter-action can occur to produce harmful, non-lubricating
compounds. If uncertain of lubricant in a gear case, drain, flush and re-fill. DON'T JUST ADO MORE LUBRICANTI
Q-1
