TM 5-3895-373-20
D.
ASSEMBLE.
1.
INSTALL AIR CONTROL PLATE ONTO
BODY.
a.
Position air control plate (52) onto body
(38). Make sure adjust slot lines up with
thumbscrew (48) threaded hole in body.
Install hex head cap screw (50) and
lockwasher (51). Tighten cap screw hand
tight.
Due to the position in which each
blower is installed, the air control
plate must be orientated in a different
direction for each blower.
b.
Orient air control plate (52) on body (38)
so the handle is in position (A) for each
blower motor being assembled. Use the
illustration as a guide.
c.
Install thumbscrew (48) and flat washer
(49) at position (B) for each blower motor
being assembled. Use the illustration as a
guide.
GO TO NEXT PAGE
14-67