TM 5-3895-385-23-1
0190
Table 1. Right Console Lights Keypad Fault Troubleshooting Procedures -- Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. Measure for continuity (WP
1. If continuity is present, proceed
0443, Vol 3) between main
to next malfunction.
wiring harness W1 J32 Pin 8 and
main wiring harness W1 J4 Pin 3
(WP 0451, Vol 3, Figures 3 and
6).
2. If no continuity is present,
replace main wiring harness
(WP 0373, Vol 2).
4. Main wiring harness has a short
Measure for continuity (WP 0443,
1. If continuity is present, replace
circuit.
Vol 3) between main wiring harness
main wiring harness (WP 0373,
W1 J32 Pin 8 and all other pins on
Vol 2).
the main wiring harness W1 J32
(WP 0451, Vol 3, Figure 6).
2. If no continuity is present,
proceed to WP 0213.
5. Keypad malfunction.
1. Attach Plus One diagnostic tool
to Bituminous Material Paving
Machine (BMPM) (WP 0444, Vol
3).
2. Turn keyless engine switch to
the AUX position, but do not
start engine (TM 5-3895-385-
10).
3. Press and hold for 2 seconds
1. If each key pressed is indicated
each key on right console lights
properly in Plus One software,
keypad and note reading in Plus
turn keyless engine switch to
One software (WP 0444, Vol 3).
the OFF position (TM 5-3895-
385-10), and replace propel
controller module Electronic
Control Module (ECM) (WP
0399, Vol 2).
2. If at least one key pressed is
indicated properly in Plus One
software and at least one key is
not indicated properly, turn
keyless engine switch to the
OFF position (TM 5-3895-385-
10), and replace right console
lights keypad (WP 0266, Vol 2).
0190-4
