TM 5-3895-385-23-1
0141
Table 1. Right Extension In Fault Troubleshooting Procedures -- Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. Hydraulic solenoid malfunction.
1. Disconnect main manifold wiring
harness W10 J26 from right
extension in hydraulic solenoid
(WP 0451, Vol 3, Figure 28).
2. Turn keyless engine switch to
the AUX position (TM 5-3895-
385-10), but do not start engine.
3. Press right extension in key on
pedestal top (TM 5-3895-385-
10).
4. Measure voltage (WP 0443, Vol
1. If voltage reads a minimum of 22
3) between pin 1 and 2 on W10
Volts Direct Current (VDC),
J26 (WP 0451, Vol 3, Figure 28)
replace right extension hydraulic
while pressing right extension in
solenoid (WP 0312, Vol 2).
key on pedestal top.
2. If voltage reads below 22 VDC,
turn keyless engine switch to the
OFF position (TM 5-3895-385-
10), and proceed to next test.
5. Disconnect main wiring harness
W1 J8 from main manifold wiring
harness W10 J1 (WP 0451, Vol
3, Figure 27).
6. Turn keyless engine switch to
the AUX position (TM 5-3895-
385-10), but do not start engine.
7. Press right extension in key on
pedestal top (TM 5-3895-385-
10).
8. Measure voltage (WP 0443, Vol
1. If voltage reads a minimum of 22
3) from W1 J8 Pin 10 (WP 0451,
VDC, turn keyless engine switch
Vol 3, Figure 1) to a known good
to the OFF position (TM 5-3895-
ground while pressing right
385-10), and replace main
extension in key on pedestal top.
manifold wiring harness (WP
0376, Vol 2).
0141-2