TM 5-3895-385-10
0022
Add Engine Coolant to Coolant Reservoir -- Continued
CAUTION
Never use water alone for coolant. Corrosion can result from using water alone. Failure to comply
will cause damage to equipment.
3. Prepare a coolant solution of 50% engine coolant and 50% distilled water.
4. Fill coolant reservoir (Figure 1, Item 7) with diluted coolant mixture up to COLD line (Figure 1, Item 8).
5. Install cap (Figure 1, Item 6) to top of coolant reservoir (Figure 1, Item 7).
6. Close right floorboard door (Figure 1, Item 1).
END OF TASK
Add Engine Coolant to Radiator
1. Remove two thumb screws (Figure 1, Item 2) and access cover (Figure 1, Item 3) from BMPM.
2. Remove radiator cap (Figure 1, Item 4).
CAUTION
Never use water alo ne for coolant. Corrosion can result fro m using water al one. Failure to
comply will cause damage to equipment.
Adding coolant to a hot e ngine can damage engine castings. Allow e ngine to cool before
adding coolant. Failure to comply may cause damage to equipment.
3. Prepare coolant solution of 50% engine coolant and 50% distilled water.
4. Fill radiator cooler (Figure 1, Item 5) with coolant solution.
5. Wait 2 3 minutes for air to vent from cooling system, and then add more coolant solution as needed.
CAUTION
Be sure to in stall radiator cap properly to avoid co olant leakage. Engine may overheat if cap is
not installed properly. Failure to comply may cause damage to equipment.
6. Install radiator cap (Figure 1, Item 4).
7. Install access cover (Figure 1, Item 3) and two thumb screws (Figure 1, Item 2) onto BMPM.
END OF TASK
FOLLOW-ON TASK
1. Verify proper operation, and check for fluid leaks.
2. Dispose of soiled rags IAW local SOP.
END OF TASK
END OF WORK PACKAGE