TM 5-3895-373-34
A.
DISASSEMBLE - Continued.
CAUTION
Use caution when removing seals
and preformed packings. Do not use
excessive force when removing seals
and preformed packings. Use an o-
ring tool. Scratched or dented seal
grooves can cause bypass leakage.
c.
Use an o-ring tool to remove preformed packing
(16) and packing retainer (17) from cylinder head
(3). Discard preformed packing and packing
retainer.
d.
Remove ring wiper (18) and compression cup
(19). If necessary, use an o-ring tool. Discard
ring wiper and compression cup.
B.
CLEAN.
1.
CLEAN
CYLINDER
AND
PISTON
COMPONENTS.
WARNING
Cleaning solvent, P-D-680, is TOXIC
and flammable. Wear protective
goggles and gloves. Use only in a
well ventilated area. Avoid contact
with skin, eyes, and clothes, and do
not breathe vapors. Keep away from
heat or flame. Never smoke when
using solvent; the flashpoint for Type
III cleaning solvent is 200°F (93,3OC).
Failure to do so may result in injury
or death to personnel.
If personnel become dizzy while
using cleaning solvent, immediately
get fresh air and medical help. If
solvent contacts skin or clothes,
flush with cold water. If solvent
contacts eyes, flush eyes with water
and get immediate medical attention.
a.
Rinse piston rod (2), cylinder head (3), cylinder
tube (4), cylinder cap (5), and piston (8) with
cleaning solvent.
GO TO NEXT PAGE
2-691
