TM 5-3895-373-20
1.7.
OFFICIAL NOMENCLATURE.
This list provides a cross-reference between the
nomenclature used in the manual and the nomenclature
specified in the Repair Parts and Special Tools List
(RPSTL). Nomenclature Cross- Reference List
Manual Nomenclature
Official Nomenclature
Paving Machine
780T Bituminous Asphalt
Paving Machine
Screed
Hydraulic Vibratory Extendable
Screed, ES-80 (Diesel)
Hopper
Aggregate Feeder
Hopper Wing
Aggregate Feeder
Auger
Screw Conveyor
Flashing
Solid Rubber Sheet
Dipstick
Liquid Gauge Rod-cap
Bendix
Electric Engine Drive
Coolant Temperature
Thermostatic Switch
Sensor
Hydraulic Oil
Thermostatic Switch
Temperature Sensor
Hemi Auger Flight
Screw Conveyor Auger
Quarter Auger Flight
Screw Conveyor Auger
Sound Foam
Sound Control Batten
Alternator
Engine AC Generator
Latch
Pawl Fastener
Fuel/Water Separator
Fluid Filter
Fuel Spray Wand
Nozzle and Hose Assembly
Assembly
Pump Drive Gearbox
Angle Drive Unit
Speed Reduction
Speed Gear Assembly
Gearbox
1.8.
USE OF METRIC UNITS.
The
equipment
described
herein
contains
metric
components
and
requires
metric
common
tools.
Therefore, metric units are used for components or
systems which are metrically dimensioned, and no U.S.
standard unit is applicable. In all other situations, U.S.
standard units and metric units are both referenced.
1.9.
PREPARATION
FOR
STORAGE
OR
SHIPMENT.
Instructions are provided in Chapter 2.
1.10.
LUBRICATION ORDER.
For lubrication intervals and instructions, refer to
Lubrication Order, LO 5-3895-373-12.
SECTION II. EQUIPMENT DESCRIPTION AND DATA
Para
Page
Battery and Toolbox Storage Compartments ........................................................................................ 1.12.3
1-8
Characteristics, Capabilities, and Data ................................................................................................. 1.11
1-3
Engine Compartment ............................................................................................................................ 1.12.1
1-3
Equipment Data..................................................................................................................................... 1.13
1-14
Hopper Auger/Conveyor Systems......................................................................................................... 1.12.5
1-10
Hydraulic Cylinders................................................................................................................................ 1.12.6
1-11
Location and Description of Major Components ................................................................................... 1.12
1-3
Relay and Circuit Breaker Panel ........................................................................................................... 1.12.9
1-13
Screed Burner System .......................................................................................................................... 1.12.7
1-12
Screed Vibrators.................................................................................................................................... 1.12.8
1-13
Track Drive System ............................................................................................................................... 1.12.4
1-9
Valve Panel Compartment .................................................................................................................... 1.12.2
1-6
1-2
