TM 5-3895-373-20
4.7. REPAIR OR REPLACE FUEL LINES, FITTINGS, AND HOSES.
This task covers:
a.
Remove
b.
Install
INITIAL SETUP
Tools:
General mechanic’s automotive tool kit
(Item 54, Appendix E)
Drip pan (Item 28, Appendix E)
Torque wrench (Item 68, Appendix E)
Utility pail (Item 26, Appendix E)
Materials/Parts:
Cleaning cloth (Item 7, Appendix C)
Hydraulic fitting sealant (Item 21, Appendix C)
Machinery wiping towel (Item 30, Appendix C)
Pipe sealant (Item 22, Appendix C)
Protective caps (Item 5, Appendix C)
Tags (Item 27, Appendix C)
Thread locking compound (Item 12, Appendix C)
Thread locking compound solvent (Item 25,
Appendix C)
Tie wraps (Item 29, Appendix C)
Brass compression sleeves
Hose clamps
Lockwashers
Rubber compression sleeves
References:
TM 5-3895-373-10
TM 5-3895-373-24P
Equipment Condition:
Left access door opened per TM 5-3895-373-10.
Left access cover removed per TM 5-3895-373-
10.
Right access door opened per TM 5-3895-373-
10.
Right access cover removed per TM 5-3895-373-
10.
Front top left access door opened per TM 5-3895-
373-10.
Front top right access door opened per TM 5-
3895-373-10.
Center top right access door opened per TM 5-
3895-373-10.
Center top left access door opened per TM 5-
3895-373-10.
Engine access cover removed per paragraph
2.22.
NOTE
This
task
provides
information
necessary to repair and replace fuel
lines. Look over the illustrations and
the
legend,
order
only
those
components required for the specific
replacements/repairs
to
be
performed. All compression sleeves,
hose
clamps,
and
lockwashers
should be replaced if removed. All tie
wraps removed during task should be
replaced. Mark tie wrap locations
and anchor points as needed.
GO TO NEXT PAGE
4-35
