3. REMOVE FUEL LIFT PUMP, ENGINE FUEL FILTER, AND FUEL INJECTION PUMP TUBES, HOSES, AND ADAPTERS

A. REMOVE - Continued - TM-5-3895-373-20_581

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
574

TM 5-3895-373-20 4.7. REPAIR OR REPLACE FUEL LINES, FITTINGS, AND HOSES - Continued. A. REMOVE - Continued. 3. REMOVE FUEL LIFT PUMP, ENGINE FUEL FILTER, AND FUEL INJECTION PUMP TUBES, HOSES, AND ADAPTERS. a. Place a machinery wiping towel beneath the lower-most fitting of the fuel hose that is to be removed. b. Remove clamps, hoses, adapters, fittings, tie wraps, and mounting hardware as required for the specific repair or replacement being performed. Use the illustrations and legend as a guide. WARNING Fuel is very flammable and can explode easily. To avoid serious injury or death: Always wear safety glasses/goggles at all times. Keep fuel away from open flame or any spark (ignition source). Keep at least a B-C fire extinguisher within easy reach when working with fuel or on a fuel system. Do not work on fuel system when engine is hot; fuel can be ignited by a hot engine. Post signs that read "NO SMOKING WITHIN 50 FEET" when working with open fuel lines or fuel tanks. c. Drain all residual fuel from disconnected fuel lines and hoses into a utility pail. Dispose of fuel in accordance with local procedures. d. Cap or plug exposed fuel system lines, hoses, and fittings to prevent fuel system contamination. GO TO NEXT PAGE 4-38

Privacy Statement
Press Release
Contact