TM 5-3895-373-20
4.2.
REPLACE FUEL LIFT PUMP - Continued.
B.
CLEAN.
Cleaning solvent, PD680, is TOXIC
and flammable. Wear protective
goggles and gloves.
Use only in a well ventilated area.
Avoid contact with skin, eyes, and
clothes, and do not breathe vapors.
Keep away from heat or flame. Never
smoke when using solvent; the flash
point for Type III cleaning solvent is
200°F (93,3°C). Failure to do so may
result in injury or death to personnel.
If personnel become dizzy while
using cleaning solvent, immediately
get fresh air and medical help. If
solvent contacts skin or clothes,
flush with cold water. If solvent
contacts eyes, flush eyes with water
and get immediate medical attention.
Use caution when scraping manifold
mounting surfaces on engine block
with putty knife. Putty knife may
score sealing surfaces and debris
may fall into engine ports. Failure to
do so may result in a poor seal and
engine damage.
1.
CLEAN FUEL LIFT PUMP MOUNTING
SURFACE
ON
ENGINE
WITH
CLEANING SOLVENT. USE PUTTY
KNIFE
TO
REMOVE
ANY
GASKET
MATERIAL RESIDUE FROM ENGINE.
WIPE SURFACE DRY WITH A LINT-
FREE CLOTH.
GO TO NEXT PAGE
4-4
