TM 5-3895-373-203.5.REPLACE EXHAUST MANIFOLD AND INTAKE MANIFOLD - Continued.A.REMOVE - Continued.2.REMOVE INTAKE MANIFOLD.NOTEExhaust manifold must be removedto get to hex head cap screws (5) onintake manifold.a.Remove hex head cap screws (5 and 6),and washers (7).b.Remove intake manifold (8) and gaskets(9, 10, and 11). Discard gaskets.B.CLEAN.Use caution when scraping manifoldmounting surfaces on engine blockwith putty knife. Putty knife mayscore sealing surfaces and debrismay fall into engine ports. Failure todo so may result in a poor seal andengine damage.1.CLEAN MANIFOLD MOUNTING SURFACESON ENGINE BLOCK. USE A PUTTY KNIFE, IFNECESSARY, TO REMOVE ANY GASKETPIECES OR CARBON BUILD UP. DO NOTSCORE THE SEALING SURFACE OR ALLOWANY DEBRIS TO FALL INTO ENGINE PORTS.GO TO NEXT PAGE3-20
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business