TM 5-3895-373-20
B.
INSTALL.
WARNING
Cleaning solvent, P-D-680, is TOXIC
and flammable. Wear protective
goggles and gloves. Use only in a
well-ventilated area. Avoid contact
with skin, eyes, and clothes, and do
not breathe vapors. Keep away from
heat or flame. Never smoke when
using solvent; the flashpoint for Type
III cleaning solvent is 200°F (93,3°C).
Failure to do so may result in injury
or death to personnel.
If personnel become dizzy while
using cleaning solvent, immediately
get fresh air and medical help. If
solvent contacts skin or clothes,
flush with cold water. If solvent
contacts eyes, flush eyes with water
and get immediate medical attention.
1.
CLEAN INSIDE OF ENGINE OIL COOLER (3)
WITH A LINT-FREE CLOTH MOISTENED IN
CLEANING SOLVENT.
2.
FILL NEW OIL FILTER ELEMENT (2) WITH
CLEAN ENGINE OIL UNTIL FULL. ALLOW
TIME FOR OIL TO SOAK INTO FILTER
ELEMENT.
3.
LUBRICATE RUBBER SEAL (4) ON TOP OF
OIL FILTER ELEMENT WITH CLEAN ENGINE
OIL.
4.
HAND ROTATE OIL FILTER ELEMENT (2)
ONTO
CONNECTOR
(5)
UNTIL
SEATED
AGAINST ENGINE OIL COOLER (3).
5.
TIGHTEN OIL FILTER ELEMENT (2) AN
ADDITIONAL 3/4 TURN USING THE OIL
FILTER REMOVAL TOOL.
6.
RUN ENGINE AT HIGH IDLE UNTIL OIL
TEMPERATURE REACHES NORMAL. CHECK
FOR OIL LEAKS.
NOTE
FOLLOW-ON-TASK: Install right access cover per TM 5-3895-373-10.
END OF TASK
2-395
