TM 5-3895-373-20REFERENCE INFORMATIONAUGER/CONVEYOR CIRCUITTo avoid reversing polarity to the voltmeter, connect negative testlead to equipment ground and use positive lead to probe for voltage.Refer to the electrical system diagram at the end ofthe diagnostic maintenance section for equipmentwiring details.Refer to paragraph 7.21 for harness and lead wirerepair.Remove screed control panel per paragraph 15.2 togain access to feeder control switch terminals.After completing diagnostic checks, close center topleft, center top right, rear top left, and rear top rightaccess doors per TM 5-3895-373-10.Install screedcontrol panel per paragraph 15.2.2-313
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
