1. REMOVE SCREED COVER PLATES

2. REMOVE MAIN SCREED BLOWER ASSEMBLIES AND FLEXIBLE PIPE

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
1010

TM 5-3895-373-20 14.8. REPLACE/REPAIR BLOWER MOTOR - Continued. NOTE There are four blower motors on the screed. Replacement and repair procedures are applicable to all of the blower motors installed on the screed. Right hand main and extension screed blower motors are shown in this procedure. Differences between right and left blower motors are addressed in text. NOTE When replacing more than one blower assembly onto main screed and extension screed, motor rotation orientation must be observed. Motors that rotate counterclockwise must be installed on right main screed and left extension screed. Motors that rotate clockwise must be installed on left main screed and right extension screed. Refer to motor label for correct rotation direction. A. REMOVE. 1. REMOVE SCREED COVER PLATES. a. Remove and discard self-locking machine screws (1). b. Remove screed cover plate (2) from the main screed. c. Remove screed cover plate (3) from extension screed. GO TO NEXT PAGE 14-60

Privacy Statement
Press Release
Contact