TM 5-3895-371-24 & P(1)spacer (6).Remove two cotter pins (9) and drive out swivel pin (5) up through yoke (42). Remove(2)Remove cotter pin (12) and pin (11) and disconnect clevis (10).i.Remove cotter pin (25) and pin (26) and pull off clevis (23).j.Remove shaft assembly (20) as follows:Shaft assembly (20) is under great spring tension. Exer-cise caution when removing.(1)Retain spring tension on bearing block (18) with pipe wrench, as shown in figure 5-5,while removing two capscrews (36, fig. 5-4), nuts (40), and washers (41); then lower pipe wrench torelieve spring tension.Figure 5-5. Remove/Install Raising Bar Spring.5-6
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
