Figure 2-60. Disconnect/Connect Swivel Toggle Rods

Figure 2-59. Remove/Install Flip Valves.

Figure 2-61. Remove/Install Spay Nozzles

TM-5-3895-371-24P Melter Asphalt Skid Mounted Hot Oil Circulating 750 GPH Chausse Model STMD-3000A Manual
Page Navigation
124

TM 5-3895-371-24&P (4) Remove spray bar as follows: (a) (b) connecting rods%) (d) Repeat steps (a) thru (g) for right side of spray bar. (Refer to para 2-38a (1).) Disconnect line (12, fig. 2-55) from ball joint (11) and remove gasket (18). Remove two cotter pins (1, fig. 2-60) and two flat washers (2); then disconnect from swivel toggle assembly (3). Remove two cotter pins from swivel pin (9, fig. 2-56) then drive out pin (9) and remove thrust washer (7). (e) Remove carry arm assembly (10). LEGEND: 1. COTTER PIN (2) 2. WASHER (2) 3. SWIVEL TOGGLE ASSEMBLY 4. SPRAY BAR 5. CONNECTING ROD (2) TA 075868 Figure 2-60. Disconnect/Connect Swivel Toggle Rods. 2-117

Privacy Statement
Press Release
Contact