TM 5-3895-371-24&PBe careful not to lose any bearing balls in the nextstep. There are 38 of them.(b)Turn carry arm assembly (4) upside down, turn inner bearing race (3); then shakethe assembly. Bearing balls will fall out.race.(c)Rotate inner bearing race (3) and allow 38 balls to drop out and remove bearing(d)Inspect all bearing balls and inner bearing race (3) for pitted condition, gouges, orother defects. Replace if defective.(e)Install inner bearing race (3).(f)Drop one ball at a time through hole for pin (6). After ball is dropped in, use smallscrewdriver or similar tool to force the ball down so that the next one can be dropped in until 38 ballsare installed.(g)Install pin (6) and secure with screw (1) and hex nut (5).(3)Remove flip valves (fig. 2-59) as follows:NOTEThe flip valve plug is lapped into the valve housing.Therefore, the flip valves are a non-serviceable itemand must be replaced as an assembly.(a)Remove two nuts (8) and lockwashers; remove valve assembly (9).(b)Remove gasket ( 1).(c)Remove pin (5) and lever (4) from valve assembly (9). (On valves located adjacentto end section swivel points, remove pin (15), washer (17), spring (16) and lever (14).2-115
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
